How do we install electronic class cards and what are the steps to install them? Many people are installing electronic class cards for the first time or watching the installation of electronic class cards for the first time. How should we install electronic class cards? Let's follow the electronic class card manufacturer to take a look!
Preparation of installation tools: Before installing the electronic shift board, we need to prepare and debug the electronic shift board in advance before leaving the factory, and prepare the relevant installation tools.
Facial recognition electronic class card
Electronic class board installation tool:
1. Power cord
2. Network cable and crystal head, pliers, scissors, Phillips/Phillips screwdriver, tape measure, etc
3. Wire duct
4. Impact drill, electric hammer
5. Electrical adhesive tape
6. Electrostatic gloves
The comprehensive wiring of electronic class cards is particularly important, and the wiring effect of class cards should be taken seriously. Customers can be asked to take photos of the classroom site in advance and develop relevant wiring methods.
Installation steps for electronic class signs:
1. Wiring: Prepare several power cords and network cables according to the number of classrooms. Then, place the power cords and network cables in each classroom and reserve a certain length of network cables.
2. Switch installation: The power switch position of the electronic class board can be uniformly installed near the switch of the teaching equipment in the original classroom. If there is a cabinet, it can be installed next to the exchange cabinet. In short, the position of the electronic class board switch should be selected based on the on-site situation of the school, with convenience for teachers as the first principle.
3. Installation of Backboard: The backboard of electronic class cards is usually installed between 1.2 and 1.5 meters above the ground. Use tools such as impact drills to open wall holes, place expansion glue, use a handheld drill to drive self tapping screws into the expansion glue, and fix the backboard in place.
4. Hanging class signs on the wall: Hang the class signs for each classroom separately. After hanging the work sign, move the class sign to the right and clamp the back plate of the class sign. Just connect the power cord and network cable. If the school's network cable conditions are good, you can also use WIFI directly without using a network cable.
5. Arrange the power cord and network cable, and connect them to the cable tray
Prepare the above installation tools and follow the installation steps shared by the electronic class card manufacturer to install the electronic class card.